Irving, TX · Dallas County

Hardwood Floor Refinishing in Irving, TX

I'm Jose, and I refinish and install floors in Irving and around Dallas County. When you call, you talk to me, and I'm the one who shows up to do the work.

I can usually start within a few days. Call or text Jose at 469-807-0987.

Floors I work on in Irving

1970s–90s homes and townhomes in Las Colinas and Valley Ranch, a mix of oak refinishing and LVP installs.

I work all over Irving: Las Colinas, Valley Ranch, Hackberry Creek and Irving Heights, plus zip codes 75038, 75039, 75062, 75063.

Recent floors around Irving

Real photos from my jobs.

What I do in Irving

  • Hardwood floor refinishing: full sand to bare wood, repairs, your stain color, 3 coats of finish. Stairs and handrails too.
  • Hardwood installation: solid and engineered, site-finished or prefinished, nail-down or glue-down.
  • LVP & laminate: waterproof vinyl plank for kitchens, baths, basements and whole houses.
  • Tile: porcelain and ceramic floors, wood-look tile, showers and backsplashes.

How it works

  1. Text me photos of the floor and the rough square footage.
  2. I give you a price and come look at it in person if needed.
  3. You pick the stain. I put down samples right on your floor so you see the real color.
  4. I do the job, clean up, and you get your house back.

Common questions

How do you price floor refinishing in Irving?

Every floor is different. The price depends on the square footage, the stain color, any repairs, and whether stairs are included. Text me photos and the square footage and I'll give you an exact price.

How long does refinishing take?

A typical 500–800 sq ft job takes 3 to 4 days: one day to sand, stain the next, then coats of finish. You can walk on it in socks after about 24 hours and put furniture back after 3–4 days.

Do you work in Las Colinas and Valley Ranch?

Yes. I work all over Irving, including Las Colinas, Valley Ranch, Hackberry Creek, Irving Heights, and the rest of Dallas County.

Can my floors be refinished or do they need to be replaced?

Solid hardwood can usually be sanded several times. Engineered floors depend on the wear layer. If you're not sure, text me a photo of the floor and the edge of a board (at a vent or doorway) and I'll tell you.

Call 469-807-0987Text