Denton, TX · Denton County
Hardwood Floor Refinishing in Denton, TX
Looking for someone to refinish your hardwood in Denton? I'm Jose. I work Dallas-Fort Worth every week, and Denton is one of the areas I'm in the most.
I can usually start within a few days. Call or text Jose at 469-807-0987.
Floors I work on in Denton
Old homes near the Square with original wood, and newer subdivisions with engineered and LVP floors.
I work all over Denton: near the Square, Robson Ranch, North Lakes and Southridge, plus zip codes 76201, 76205, 76207, 76210.
Recent floors around Denton



Real photos from my jobs.
What I do in Denton
- Hardwood floor refinishing: full sand to bare wood, repairs, your stain color, 3 coats of finish. Stairs and handrails too.
- Hardwood installation: solid and engineered, site-finished or prefinished, nail-down or glue-down.
- LVP & laminate: waterproof vinyl plank for kitchens, baths, basements and whole houses.
- Tile: porcelain and ceramic floors, wood-look tile, showers and backsplashes.
How it works
- Text me photos of the floor and the rough square footage.
- I give you a price and come look at it in person if needed.
- You pick the stain. I put down samples right on your floor so you see the real color.
- I do the job, clean up, and you get your house back.
Common questions
How do you price floor refinishing in Denton?
Every floor is different. The price depends on the square footage, the stain color, any repairs, and whether stairs are included. Text me photos and the square footage and I'll give you an exact price.
How long does refinishing take?
A typical 500–800 sq ft job takes 3 to 4 days: one day to sand, stain the next, then coats of finish. You can walk on it in socks after about 24 hours and put furniture back after 3–4 days.
Do you work in near the Square and Robson Ranch?
Yes. I work all over Denton, including near the Square, Robson Ranch, North Lakes, Southridge, and the rest of Denton County.
Can my floors be refinished or do they need to be replaced?
Solid hardwood can usually be sanded several times. Engineered floors depend on the wear layer. If you're not sure, text me a photo of the floor and the edge of a board (at a vent or doorway) and I'll tell you.